header.png

SEPTEMBER SPECIALS

PIT KIT

Part #: 162-8248
Kit Contains:

PART NAME PART # QTY
JOGGER ARM 162-8024 2
PIT MOUNTS 162-2034 12
LBWGR-SOLID 162-8001 1
LBWGR-SPLIT 162-8002 1
162-8024 copy.jpg
162-8001 copy.jpg
162-2034-grayscale copy.jpg
162-8002 copy.jpg

Frustrated by alignment issues?  Our Jogger Arm is the answer to this problem.  The UHMW insert eliminates the need for the needle bearing and spacer.  The needle bearings tend to wear over time due to the fact that they don’t make a full revolution.  The hole in our design is always centered, which cannot be done on a cast arm.  This, combined with our precision machining, helps you achieve perfect alignment.  This assembly is built from tough billet aluminum and also includes a PEER® rubber seal bearing.

Stay out of the pit!  Are you tired of going back into the same pit conveyor assemblies and constantly replacing the conventional rubber pit mounts due to melting or structural failure?  Our Neoprene Pit Mounts go through an astringent curing process, and incorporate a Grade 8 stud, making them more durable and ensuring they will not prematurely separate.  A little more expensive, but well worth the extra cost!

With traditional guide rollers, the urethane will degrade, screws will back out, flanges will snap, and it’s only a matter of time before you’re spending money to replace them.  We are confident in saying that our Guide Rollers will outlast the original version.
What’s our secret?

  • High quality UHMW construction. 
  • Proven reliability of PEER® rubber seal bearings.
  • Thicker flanges for better tracking.

TOP SIDE TUNE-UP KIT

Part #: 163-8006
Kit Contains:

PART NAME PART # QTY
SHARK TRANSITION CAM 163-6008 1
CROSSOVER WEDGE 163-8011 1
55” RED BELT (12.5 MM) 163-9020R 2
32” RED BELT (12.5 MM) 163-9020R 4
_MG_2809-gray copy.jpg
wedge 2 copy.jpg
163-9020_163-9007 copy.jpg
wedge-hardware-gray copy.jpg
 

The Shark Transition Cam aids the pin as it exits the shark assembly by providing a gentler angle for the base of the pin to strike. It also dampens the rebound of the head of the pin, reducing “fish tailing” while traveling.

The Crossover Wedge allows the pin to exit the crossover with a more consistent motion.

Kegel’s Red Polycord is quickly becoming the standard in the industry. It has a tacky, smooth surface that grips the pins and is easy to clean! Install it on your shark assemblies and crossovers and say “goodbye” to pile ups!